Aglaia Wood Primer

General information

• Check substrate suitability as required (see 2.1 and 2.3). Pay particular attention to the absorbency, strength and texture of the respective substrate. Try out on a test area before using on high quality and critical surfaces. Ensure that the product is used by qualified persons only.
• Carefully cover surfaces which are not to be treated – especially glass, window sills, expansion joints, lacquer, plastics and hardware – and protect them from splashes.
• Shake up canister before use.
• Provide personal protective equipment.
• Do not use in wet conditions, or on hot surfaces.
• Minimum application temperature: +16°C
• Ensure sufficient ventilation and heat (room ambient temperature) for drying.
• Drying time per coat: in normal climate is ready to coat over after at least 24 hours. Only coat over dried primers. Tack-free in normal climate after several days, avoid excessive coat thicknesses and gluing up/clogging, e.g. in door rebate. Handle fresh coatings carefully.

Application

• In the system: BEECK Wood Primer is sold ready to use and is applied unthinned by brushing, spraying, flow coating or immersing.
• Saturate the wood well, after around 20 minutes carefully use a brush to spread excess coating on the surface.
• Also brush out well on rough and cracked wood.
• Excess surface material must also be carefully removed from horizontal surfaces and pockets with a brush and / or compressed air if using spray methods, immersion or flow coating. Do not allow any “lakes”, surplus material or runs and sags to dry on. A sample application is advisable.
• Note the risk of auto-ignition in extractor filter mats in case of oily overspray.
• Carefully sand down shiny patches after drying; they cause adhesion imperfections and drying delays.
• Before applying the following coating sand the surface until finely matt (grit size approx. 240), especially on swellable and rough wood and in case of dust inclusion and glossy excess surface material.