Aglaia Undercoat/Precoater
White matt linseed oil base coat for wood and ferrous metal, for interior and exterior use.
Next Day Pallet
Parcel Delivery
White matt linseed oil base coat for wood and ferrous metal, for interior and exterior use
General information
- Check substrate suitability as required (see 2.1 and 2.3). Pay particular attention to the absorbency, strength and texture of the respective substrate. Try out on a test area before using on high quality and critical surfaces. Ensure that the product is used by qualified persons.
- Carefully cover surfaces which are not to be treated – especially glass, window sills, expansion joints, lacquer, plastics and hardware – and protect them from splashes.
- Provide personal protective equipment.
- Stir thoroughly before use.
- Do not use in wet conditions, if there is a risk of frost, on hot surfaces or in the blazing sun.
- Minimum application temperature: +8°C. Ensure ventilation and heat (room ambient temperature), handle fresh coatings carefully.
- Drying time per coat: in normal climate is ready to sand and coat over after at least 24 hours
- Only coat over dried primers. Tack-free in normal climate after several days, avoid excessive coat thicknesses and gluing up/clogging, e.g. in door rebate.
- Protect fresh exterior coatings from the rain; hang up scaffolding sheeting in front of the surface worked on.
Application
- If using BEECK Undercoat in the system, apply with a round brush, flat brush, painting roller or a spraying method (low pressure, high-pressure, air-mix).
- Apply thin coats, smoothly, seamlessly and uniformly.
- Avoid excessive coat thicknesses, spread out well including on rough substrates.
- If necessary, thin with up to 3 % BEECK Lacquer Thinner, especially on absorbent and rough substrates and if using a spray coating method.
- 1 – 2 coats as required, e.g. on highly contrasting or large-pored substrates. Ensure good edge cover.
- After at least 24 hours, finely sand or grind, if necessary, the surface, remove dust and paint over.
- Also avoid excessive coat thicknesses if using spray coating method; carefully spread excess material on the surface with a brush. Do not allow any “lakes” fat edges or runs and sags to dry on the surface, especially on horizontal surfaces and in recesses. A sample application is advisable.
- Note the risk of auto-ignition in extractor filter mats in case of oily overspray.
Suitable For
- Priming coat for wood and ferrous metals for interior and exterior use
Coverage Rate
- 12-13m² per litre
- For use on interior and exterior surfaces
- Highly adherent on diverse substrates
- Low tension, does not tend to flake off
- Can be coated over practically an unlimited number of times
- Open-pored, diffusible and sorbable
- High yielding, easy-to-use high solid
- Traditional formulas suitable for listed buildings
- 750ml
- 2.5l
Customer Questions
No Questions
Please, mind that only logged in users can submit questions
BEECK's - Undercoat/Precoater - Data Sheet (522.09 kB)